ENDER 3 S1 PLUS Gantry Reinforcement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a design to reinforce the Z axys Gantry on the Ender 3 S1 PLUS to minimize wabble. You need to print the Top…
- Ocena
- 0 / 5
- Polubienia
- 42
- Pobrania
- 143
- Wydruki
- 1
- Wyświetlenia
- 1419
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a design to reinforce the Z axys Gantry on the Ender 3 S1 PLUS to minimize wabble.
You need to print the Top Left and Top Righ part as well as one pf the 3 available versions for the bottom parts:
V3 fits the stock printer (might need foot a bit taller than the original rubber foot of the printer, to be verified)
V2 is a version that fit small foot like V3 and the honeycomb bottom plate that you can find here: 778623
V1 is the Original version. It is a bit stronger and fit the honeycom bottom plate (778623) as well as the taller foot i designed that you can fin here: 778618
This design can fit with a Creality Light Bar screwed on the side of the Z axys Gantry (see picture)
Print Settings
Rafts:
No
Supports:
No
Resolution:
0,36
Infill:
30%
Filament: Sunlu PLA
Notes:
The best print orientation is pictured
For the installation you will need:
2 Threaded Bar M8 x 550 to 580mm (depending on the Version you choose)
8 M8 Locknuts
8 M8 x 15/20 mm metal washer
4 M5 x 35+mm Screws to replace de original ones on the Top Parts
Category: 3D Printer Parts