1 / 4
Creality K1/K1 Max Corner Mount for 3D Chameleon Y splitter — zdjęcie 1
1 / 4

Creality K1/K1 Max Corner Mount for 3D Chameleon Y splitter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Here's my mount for securing the 3D chameleons Y splitter in the corner of the K1/K1 Max

Ocena
0 / 5
Polubienia
50
Pobrania
173
Wydruki
0
Wyświetlenia
2621
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

As requested, here's my mount for the 3D Chameleon's Y splitter. This allows you to mount the splitter securely to the top right backside corner when using the 3D Chameleon install video I created for the K1/K1 Max 

Print notes; 

-Print the securing cap at minimum of 35% infill. It tends to break if printed any less than that. Otherwise print the base at 15% or higher (Easier to just print both at 35%) 

-No supports needed just print in orientation I have set. 

You will need the following screws:

2x M3x8mm for securing cap to base (I used socket head but either should work)

2x M3x12mm for Base to printer (Button head works best) 

When attaching the securing cap to the splitter, it tends to be very snug. Don't force it too much otherwise it will break. But it should just pop on with a little force. (I uploaded models separate incase the securing cap breaks)

Tagi