Profitec Pro300 handles for hot water steam valve - Profitec Pro300 Griffe für Heisswasser-Dampfventil
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Handles for espresso machine, 2 colours Griffe für Espressomaschine, 2 farbig
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 347
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Handles for the hot water / and steam valve
Profitec Pro300 with 6 mm valve axis
The core (here made of orange Prusa ABS) should be printed from ABS or a similar material, as other materials become soft and deformed by the heat.
I printed the handle body itself from PETG in 2 colours.
This is then simply pushed onto the "core".
Variable layer heights were used in the slicer so that the curves appear more elegant and finer.
The handle body was sprayed with clear varnish and is therefore easy to clean from coffee stains.
Otherwise, it can also be easily removed from the handle core and cleaned with warm water.
I used pointed pliers to remove the support materials and reworked some areas on the prints with diamond files so that the core fitted tightly (firmly) on the 6 mm valve axle and the handle body could be pushed onto the handle core.
Happy print :)
----------------------------------------------------------------------------------------------------------------
Griffe für das Heisswasser- / und Dampfventil
Profitec Pro300 mit 6 mm Ventilachse
Der Kern (hier aus orangenem Prusa ABS) sollte aus ABS oder ähnlichem Material gedruckt werden, da andere Materialien durch die Wärme weich werden und sich verformen.
Den Griffkörper selbst habe ich aus PETG in 2 farben gedruckt.
Dieser wird dann einfach auf den “Kern” aufgeschoben.
Im Slicer wurde variable Schichthöhen verwendet, so dass die Rundungen eleganter und feiner erscheinen.
Der Griffkörper wurde mit Klarlack besprüht und ist so leicht von Kaffeeflecken zu säubern.
Ansonsten kann dieser aber auch leicht vom Griff-Kern abgezogen werden und mit Warmen wasser gereinigt werden.
Zum Entfernen der Stützmaterialien habe ich eine Spitz-Zange verwendet und vereinzelt Stellen an den Drucken mit Diamantfeilen nach gearbeitet, so das der Kern stramm (fest) auf die 6 mm Ventilachse passte und der Griffkörper auf den Griffkern geschoben werden konnte.
Happy Print :)