Craftsman Screwdriver Holders - Gridfinity
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Gridfinity based holders for Craftsman screwdrivers.
- Ocena
- 5 / 5
- Polubienia
- 97
- Pobrania
- 476
- Wydruki
- 2
- Wyświetlenia
- 2765
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This Gridfinity based Craftsman screwdriver holder was made to allow you to print for each screwdriver separately to accommodate individual collections while conserving filament. I didn't think the holder needed to house the entire screwdriver shaft and found that only the handle needed to be supported for this to work properly. Magnet holes are included if you use them. Each screwdriver is sized for the Craftsman screwdriver handle listed. I have not tried every handle out there, just the ones I have. Listed below are the files and Craftsman model.
PH3 and SL ¼ Holder = CMHT65009 and CMHT65015
PH2 and SL 3/16 Holder = CMHT65004, CMHT65005, CMHT65023, and CMHT65021
PH1 Holder = CMHT65002
PH0 Pocket Holder = CMHT650000
Phillips Stubby Holder = CMHT65003
SL 1/8 Holder = CMHT65018
SL 1/8 Pocket Holder = CMHT65017
Flat Stubby Holder = CMHT65013
I printed mine using colors that coordinated with the handle colors (I ran out of red, don't judge me). Printed at 0.2 layer heights, 3 walls, and 5% infill.