KLP1 runout sensor

This object is meant to fix filament tube and to move the runout sensor to a more sensible place.

The filament tube is fixed, so you do not need three hands to load filament anymore - now you can push the filament into the runout sensor and hold the filament lever on the print head open at the same time :-)

The runout sensor is moved to a place, where it is closer to the center of a filament spool and a little further away from the spool.

Printed in PLA, 0.2mm, 15% infill.

BOM:
* 2 x Screw M3 8mm
* 2 x Screw M3 10mm
* 4 x Heat inserts for M3, Diameter=4mm, Height = 5mm (adafruit 4255)
* 3 x short wires <= 10cm
* 1 x JST XH 2.5 3 pin female connector  (adafruit has a JST XH 2.5mm set)
* 1 x JST XH 2.5 3 pin male connector
* A little soldering wire
* A little electricians tape

Tools:
* Soldering iron
* Screw driver or hex key for screws

Instrutions:
* Print the object - it contains the base part and a tube holder.
* Use the soldering iron to insert the four heat insert as show in the picture.
* Mount the original runout sensor to its new position.
* Use the soldering iron to prepare the small extension cable as shown in the picture - it is straight through, so female pin 1 to male pin 1, female pin 2 to male pin 2, and female pin 3 to male pin 3.
* Detach the runout sensor from the printer and attach the extension cable to the cable coming out of the printer.
* Mount the runout sensor on the printed base using the original screws.
* Mount the base to the printer using two 8mm screws.
* Attach the free end of extension cabel to the runout sensor.
* Use electricians tape and attach approx 1½ turns around the tube.
* Place the tube in the cutout on the base and attach the small tube holder part with two 10mm screws - the tube has to be flush to the runout sensor. Tighten and check the tube is attached securely by trying to pull it out - if not, dismount and try with more turns of tape.

I've originally used it with the spool holder found at https://www.printables.com/model/597464-improved-spool-holder-for-kingroon-klp1.

However, I needed a wider spool holder so I designed this one: https://www.printables.com/model/813081-klp1-wide-spool-holder.

You can find the design at https://www.tinkercad.com/things/6dh78eNODfc-public-copy-of-klp1-runout-sensor - please make a copy before modifying!