1 / 4
Filament Straightener for ESteps Calibration (1.75mm)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Features: Holds filament straight for easy measuring Easy and fast print! No supports needed Self-centering Tapered…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 91
- Wydruki
- 0
- Wyświetlenia
- 712
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (13)Powiązane
Features:
- Holds filament straight for easy measuring
- Easy and fast print! No supports needed
- Self-centering
- Tapered entry hole so filament loads through every time
Fits 1.75mm filament Procedure:
- Install the straightener into your extruder body. The top of the tool has a groove mount that will self-center into the matching part of the extruder body. (See photo)
- Extrude some filament through so that a small amount is showing. (See photo)
- Use the depth end of a caliper to measure the distance from the end of the tool to the end of the filament. Zero out the caliper at this point. (see photo)
- Extrude 100mm of filament and measure again in the same fashion. If you zeroed out the caliper at the end of step 3, it will show the amount actually extruded. Ignore the negative sign. Now you can proceed with calculations or guess-and-check to dial in until your esteps are as accurate as you like!
Print Settings
Printer Brand:
Prusa
Printer:
Mk2.5s
No
Supports:
No
0.2
Infill:
40%
Filament:
Paramount3D PLA Decepticon Purple
Notes:
if using Slic3r/PrusaSlicer/SuperSlicer: Print with 4 perimeters, fewer perimeters will cause the infill to squish the hole too tight for
Less infill (25%) would probably work fineCategory: 3D Printer Accessories