Bambu Lab P1P Stand/Riser with Drawers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I saw a similar model on MakerWorld but this is 100% my design from scratch using that idea.
- Ocena
- 0 / 5
- Polubienia
- 41
- Pobrania
- 215
- Wydruki
- 0
- Wyświetlenia
- 2272
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
UPDATE (3/10/2024): added new trim parts for X1C as they are 8MM shorter when not using the squash ball feet. Also the middle section of the poop shoot needed to be reduced to 185mm. Thank you very much to @alaemmerhirt_828064 for helping me get the correct measurements for the standard X1C with factory feet.
UPDATE (2/27/2024): added corner support for standard feet that come on the X1C/P1P/P1S (assuming they are all the same size rubber feet). It seems the X1C has a slightly smaller footprint than the P1P that I have and designed this for. Also a shorter version of the middle poop shoot section to accommodate the shorter stance with the factory feet. They are in a separate folder named "X1C Specific"
I have a P1P and designed this for that model but I am pretty sure this will also work for the X1C and P1S as I believe they have an identical footprint. I also have the Anti vibration foot [Bambu Lab X1/ X1C] (design by @MIRCON_809183) using squash balls. This was designed with that in mind.
- Printed using NuMakers PLA+
- .20 layer height on most of the structural parts
- .16 layer height on the drawer fronts, drawer handles, trim pieces, etc
The drawers slide pretty well but will slide even better if you add a little lubrication to the rails. I used a squirt of Blaster Multi Purpose