Speaker Stand (Bose Companion 2 Series II compatible)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A stand for speakers, designed with the Bose Companion 2 Series II in mind. 8x13x20 cm, no supports needed.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 92
- Wydruki
- 1
- Wyświetlenia
- 910
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
The stand elevates your speakers 20 cm above your desk in an aesthetically pleasing way. At the back there is a little recess where you could clamp it to your desk. Overall it is quite sturdy while appearing lightweight. You can easily print it in two colours with only one filament change. The top plate is separate and the same height as the bottom plate, so you can print them on one plate and make a filament change after the bottom/top is done.
I posted the step files so you can make adjustments as necessary and so the curves are nice and round.
Printing instructions:
- I used Polyterra PLA with 0.2 mm layer height. I would not suggest going thicker because there are two small alignment cones between the column and the top plate and they might not work as well with thicker layers.
- Print the top with the small conical wholes facing upwards, the bottom does not need supports.
- Optional: Add a filament change after the plates are done to achieve a nice two-colour result.
Assembly:
- Just glue the top onto the bottom. There are two alignment cones that ensure a good fit. Make sure the rounded corners of the top plate face forward. Spread the glue along the whole contact area so there is a strong bond.
I hope you will enjoy the model and its aesthetics. Let me know if there are any improvements or additions you would like to see.