Rear mudguard and footrest for Dualtron
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A footrest and semi-flexible rear mudguard for Dualtron electric scooters
- Ocena
- 5 / 5
- Polubienia
- 22
- Pobrania
- 418
- Wydruki
- 0
- Wyświetlenia
- 2634
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
Compatible with Ultra, Thunder, DT3, Compact, DT2, Raptor 1, Victor.
Semi-flexible rear mudguard
Comes in 2 parts:
- Mudguard
- Bottom support
And 1 optional top plate if you don't have anything to secure the mudguard in place.
The mudguard should be printed in TPU (A98) in order to remain flexible but also to keep its shape. You can (like in the picture) shape it with a heatgun for a better fit.
The bottom support only purpose is to give a rounded shape to the mudguard and can be printed either in PLA, ASA, ABS or PETG.
Foot rest
Three versions with angles at 30°, 20° and 20° with flat top-surface and larger holes for the screws on the back (if you want to add washers).
Print orientation: preferably upside down, with supports.
Material: ABS or ASA if you plan on carrying the scooter with it. Otherwise, PETG or even PLA are fine.
Print settings: 3 perimeters 20% up to 30% cubic. You can reinforce the surfaces around the screws with cylinder-shaped modifiers at 100% infill.
Note
If you use both the footrest and the mudguard, you may have to use longer screws because of the extra width.