Winnie The Pooh Lamp and Night light

Hello! I searched the internet looking for a winnie the pooh lamp to go with my baby son's room theme and all I found was one "hunny" pot lamp selling for $100… so I created my own lamp and nightlight. It is designed to all fit in on one print bed on my Bambu lab X1 carbon. 

I recommend printing with 5% concentric infill with support for the lid and used 2 walls setting for outer and inner walls. The honey pot does not need support and the lid probably doesn't either but I printed with support on the bottom of the lid only for peace of mind. The model is design to be printed in its current wall thickness, not vase mode.   

I used two under cabinet, led lights that were pre-wired and easy to incorporated into the lamp without any soldering.  Here is the light set I used from amazon:  GETINLIGHT 2.75" Wide 3000K Dimmable LED Puck Lights Kit, Plug-in Installation with recessed or Surface Mounted, Bronze Finished, Set of 3, IN-0102-3-BZ https://www.amazon.com/dp/B01LAN41Z0?ref=ppx_yo2ov_dt_b_product_details&th=1 but any plug-in, LED lights should work. I chose that light set since it came with a dimmer and on/off switch. I ended up using two of the lights instead of all 3 since it was plenty bright with just 2 of them. The lamp works really well with a total of 4 watts of LEDs (2 x 2 watt led lights). 

To secure the lights inside the “hunny pot”, I hot glued one light at the very bottom and one on the backside of the lamp just above the first light. I've included a picture of the light locations with the model. 

Please let me know if you have any questions and I plan on uploading more lamps in the future.