1 / 2
Reinforced Wyze Cam OG front glass mount for Bambu P1S/X1C — zdjęcie 1
1 / 2

Reinforced Wyze Cam OG front glass mount for Bambu P1S/X1C

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A reinforced version of the Wyze OG cam holder for the glass door of Bambu Lab P1/X1 series

Ocena
5 / 5
Polubienia
28
Pobrania
225
Wydruki
2
Wyświetlenia
1252
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

2026-02-12: Check the size of your OG Cam, if it's 52.2x52.2 like @Negarpls_3674399 mentioned in the comment section, this version might not support your camera. I released the .STEP file, though, if you make the change, share a remix, this is the good in the 3D printing community, pay it forward!

You can refer to the original for instructions.

But in summary, use a piece of filament or a toothpick (my case) to bind the clip to the mount.

Print the clip tall on it's “side" with supports

Print the mount body facing down the bed, no supports are needed

Tagi