Azteeg X3 stepper driver 40mm fan bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fan bracket for the Azteeg X3 printer controller board.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 81
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
2014/03/02 Update: The customizer file had no closed surface. Uploaded a netfabb fixed version
Customized version of http://www.thingiverse.com/thing:166045
Customized to fit the Panucatt Azteeg X3 controller on a Bukobot 8 V2 duo. It additionnaly stops the wireguide of the printhead to hit and detach the heatsinks from the stepper drivers
Clearance for the stepper motor heatsinks is adjusted for Enzotech MOS-C10 copper heatsinks.
http://www.panucatt.com/Azteeg_X3_reprap_3d_printer_controller_p/ax33dp.htm http://www.bukobot.com/
Instructions
Printed on a Bukobot 8 V2 duo with PLA .15mm layer and 50% infill on Avery J8567 clear inkjet shipping label @65°C bed
The slow running (and thus quiet) fan shown keeps the stepper drivers perfectly cool, even the two outermost which are not in the direct air flow.
The following options were used for the customizer:
bracket_length = 10
pcb_width = 51.5
bracket_thickness = 3.0
fan_hole_spacing = 32
bracket_height = 23
screw_diameter = 3.9
cross_bracket = 5
fan_size = 40
Category: 3D Printer Parts