1 / 2
DIY Print Bed Filament Dryer (with Prusa MK4 drying GCode) — zdjęcie 1
1 / 2

DIY Print Bed Filament Dryer (with Prusa MK4 drying GCode)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Dry your filament using your print bed and a 4010 fan, updated with GCode for Prusa MK4

Ocena
4,667 / 5
Polubienia
30
Pobrania
260
Wydruki
2
Wyświetlenia
2341
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

The awesome filament dryer design and gcode by @Leftcetio, but with GCode that works on Prusa MK4 and extends the drying time to 6 hours.

Read the original creator's description first, it explains a lot in great depth. This description is mostly my own notes.

I modified the GCode and tested it on my MK4 and it now works properly. I added even more comments and explained every command so feel free to check it out. The most important command is M86 [time], which basically sets the safety timer timeout to 6 hours and therefore the printer doesn't shut off the heatbed after 30 minutes (default). Even though M86 does its thing, I left @Leftcetio's 10 minute breaks (line 24-166) just so the percentage and time remaining would keep being updated on the printer's screen.

The M86 command shows up as an error when uploading to Printables, therefore the GCode file needed to be added as .zip. 

Printing

  • For durability and temperature resistance, print the model in ASA/ABS. If not possible, PETG is the next best option and if you only have PLA, it'll work, but it will warp after a few uses. If printing with ASA/ABS, make sure to use a brim if you don't have an enclosure, but keep in mind the brim will hide the zip-tie hole on the fan mount (Filament_Dryer_Fan_Mount) so just gently poke it out with a precision knife to expose the hole again.
  • If you don't want to use supports, cut the base (Filament_Dryer) at Z position 12.02 and then glue the pieces back together. That's what I did in the photos.
  • Layer height: 0.20 or more
  • Infill: 15% worked for me but it's irrelevant if you're printing with PETG/ASA/ABS

Usage

  • Remove the printing sheet before placing the filament dryer
  • Use a thicker cardboard box (insulation) and for best results, get some aluminum tape and cover the insides with it. It'll keep the heat in better.

Tagi