Digilogue LED Clock - WLED Clock

This is my “Digilogue Clock”. This uses a ring of 60 LEDs to be able to show the time, syncing with network time. As it uses the WLED firmware it is able to do all the lightshow's that WLED can do and also show the time!

The clock can be mounted one of two ways, either on a desk or on the wall. Which parts are printed and used depend on the mode:

Common

• LED Digilogue Clock - Case - Front*
• LED Digilogue Clock - Case - Rear
• LED Digilogue Clock - Internal Spacer

Desk

• LED Digilogue Clock - Base
• LED Digilogue Clock - Base - Plug

Wall

• LED Digilogue Clock - Blanking Plug

*best use the 3mf as there are different layers for light diffuser

The front of the clock integrates a filter (0-0.8mm,) diffuser (1.0-1.2mm) and the segment dividers (1.4mm+). The filter uses a smoked transparent plastic (Ooznest Lucid Black PETG), the diffuser is PETG white and the dividers are a dark grey. The Lucid Black adds contrast to the display, the white diffuses the light and the dividers need to be dark to prevent light bleeding.

Here is my Github which has the controller PCB:

https://github.com/chipnotic/WLED-Controller