Astroberry Case and Cradle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A case for a Raspberry Pi 4 and uBlox-6 GPS - plus a cradle that snaps onto a 45mm tripod leg
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 284
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed a case to house a Raspberry Pi4 and a GPS Module that I will be running Asroberry on. I found Ron's modular case for Pi's with HATs, modified it a little to remove some unneeded features, and created the modular section that slides into the side of the case that holds the GPS module.
I also created a cradle for the case that snaps onto my telepscope mount's leg (Skywatcher EQ5), but it should fit any round tripod leg that has the same diameter (45mm / ~ 1.75")
The GPS used is a GY-NEO6MV2 NEO-6M
Case for printed in black generic ABS, 15% infill and with no supports.
M3 fasters of suitable length and matching nuts hold the GPS on the holder. M2 screws, washers and nuts secure the Pi4 in the case.
Pi GPIO to GPS pins are:
GPIO 5V (Pin 4)→ GPS VCC
GPIO GND (Pin 6) → GPS GND
GPIO UART RX (Pin 10) → GPS TX