Yamaha SEQTRAK Clip-On Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed a Stand to fit the SEQTRAK and holds it at a 35° so you can see all the labels while using it.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 198
- Wydruki
- 1
- Wyświetlenia
- 1106
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial
You'll need to print 2. Mount them fairly wide is best, see photos. Be aware of where the front and back buttons are when sliding them on/off. Make sure you position them far enough away to still allow easy usage of the buttons.
No supports required. Any layer height and infill should be fine. I used normal defaults of 0.2 and 15%. It fits fairly tight because I don't want them slipping off when you adjust or lift the SEQTRAK.
You might want to use a PLA or PLA+ that has a little flex. Something too stiff like a PETG might damage the SEQTRAK if you try to force it on. You could scale up 1-2% to make the fit a little looser or to work with a very stiff plastic.