iOptron Tri Pier 360 Shelf for Mele Quieter 4C
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shelf for the Mele Quieter 4C to fit on iOptron's 360 tri-pier.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 631
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A shelf for the Mele Quieter 4C mini PC that fits on the iOptron 360 tri pier. It uses the pre-existing 3/8" threaded holes on the top plate to mount the shelf. Since the fanless Meles run hot, I designed a bracket to mount the Mele . The bracket is mainly space to allow airflow on the mele's bottom which I helped along further by elevated pads on the bracket. The shelf also has a cutout matching the bracket's bottom. The bracket is then mounted to the shelf proper via M5 screws through the shelf into the threaded inserts on the bracket. I follow Patriot Astro's advice and rest a heat sink on the Mele's top as well. Wire looms on the side and front provide stress relief for the cabling. I had to extend the “front” wire loom to enlarge the distance from the Mele. My print bed is not big to make the shelf larger in that direction (it fills the mk3s+ bed). This setup remains well clear of my rig. Be sure to check clearances on yours before getting too far.
Print stats: .8mm nozzle, PETG for all colors. 250C/90C.
UPDATE: You may have noticed, there are 4 holes in the shelf unspoken for. These are for a roof I had not yet validated. I just printed and it fits well. Although the mele runs warm enough that dew condensation is probably not a problem, I was concerned about condensate dripping from the OTA above. Just posted the roof STL file if you deem it necessary.