Craftbot FLOW IDEX extruder mount for Bondtech LGX lite V2 extruder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Extruder mount for Bondtech LGX lite V2
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 202
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
Please keep in mind that the hotend must be electrically connected to the base. Since one part of the extruder mount is non conductive 3D printed plastic, you have to install a wire that connects the hotend to the head base/board.
How I've made this is that I took about 7cm of wire and crimped a ring eye connector on each end. Then I attached one connector to the screw that holds the FMS board(on the hotend).
Then I connected the other end to the screw that holds the extruder motor. Make sure that the wire or the connector do not interfere with the rest of the extruder. Make the wire as short as possible, for easier assembly.
TIP: Print the mounts with a high temperature filament like ASA, ABS, PACF….
Add this to your start script in your slicer:
M2160 T1 E550 ;this command modifies the T1 extruder motor current to 550mA
M2160 T0 E550 ;this command modifies the T0 extruder motor current to 550mA
M5001 E1.850 ;this command modifies the extruder steps