Hasbro Tie Striker (Rogue one) wing replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Recently I bought a Tie Striker in a flea market without a wing. My son was so excited with it that I did a spare wing.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 267
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
//* Nerf dart carrier uploaded, sorry I forget it
Recently I bought a Tie Striker in a flea market without a wing. My son was so excited with it that I did a spare wing for replace the missing one.
There is two versions:
Ala.stl is the full wing panel.
punta.stl medio.stl popa.stl are the same wing but divided in three to fit in a 20x20x20 printer.
Then as common files:
tapa.stl
tapa_ala.st
lanclaje.stl
Those conform the link with the ship, you should consider use screws in this part as its the most easily breakable area so you can replace "anclaje.stl" easily.
Finally glue "tapa_ala" with the wing with strong glue or epoxi.