Cherry Blossom Filament Sample
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted this flower as a filament sample because it was so cute!
- Ocena
- 5 / 5
- Polubienia
- 30
- Pobrania
- 221
- Wydruki
- 2
- Wyświetlenia
- 825
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
I was inspired by this Simple Flower Filament Sample.
However, my favorite flowers are cherry blossoms so I looked high and low and found this amazing cookie cutter!
So I remixed it that was able to print it properly.
I did several versions, so i uploaded these too. :)
The label inlet on the back is around 12mm high. It fits my dymo labels.
Edit 2024-03-17:
I was inspired by a lot of other filament samples that had areas of different layer heights.
I changed it a bit and now it has a scale from 0,2 to 1,2mm. It should be printed on the “face”.
It uses around 5.5g of filament and requires no supports.
If you require a hole, simply add one via the slicer of your choice :)