1 / 7
51x51x25mm blower fan holder and duct for Wanhao Duplicator i3 — zdjęcie 1
1 / 7

51x51x25mm blower fan holder and duct for Wanhao Duplicator i3

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I wanted a bit better fan on my Di3, but i didn't have any 51x51x15mm blower fans at home. But i did have a 25mm thick…

Ocena
5 / 5
Polubienia
3
Pobrania
11
Wydruki
1
Wyświetlenia
361
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

I wanted a bit better fan on my Di3, but i didn't have any 51x51x15mm blower fans at home. But i did have a 25mm thick one, so i made this holder and duct to improve my performance.

Bridge test used: http://www.thingiverse.com/thing:12925/#made

Print Settings

Printer:

Wanhao Duplicator i3

Rafts:

Doesn't Matter

Supports:

No

Infill:

0% on duct, 20ish% on holder

Notes:

The shell on the duct i set to 1mm and and that gets weird on the curved bits, set to 0% or you might see som eratic behaviour from your printer trying to infill the tiny space.

Post-Printing

Screw on the fan to the mount with a long M4 screw, nuts and washers, the holder is a bit loose, you should be able to fit one washer on between the inside of the holder and the fan.

Attach the holder to the fan mount on the head with M3 screws, nuts and washers. The mount can slide sideways.

Flip the fan up and attach the duct, it should sit firm just by friction, if not use glue, tape or whatever.

If you have kapton in 5-10mm width you can wrap the hot end a few turns to increase the insulation.

Flip down the fan and make sure its not to low and might interfere with your print and everything seems reasonably firm.

Category: 3D Printer Parts

Tagi