Cable clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cable clips for installation under the overhang of the roof.
- Ocena
- 4,9 / 5
- Polubienia
- 610
- Pobrania
- 1341
- Wydruki
- 14
- Wyświetlenia
- 4785
- Oceny
- 10
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a cable clip that can be used in the corner between the wall and the roof overhang where it can be difficult to install with standard cable clips.
I made a couple of variants of the cable clip, one for a 20 degree roof pitch, one for a 30 degree pitch and a standard cable clamp for normal wall mounting.
Installation
The cable clip is intended to be used for a cable with a diameter of 10 mm and with a countersunk screw with a diameter of 3 - 4 mm.
Printing and print settings
Print the clips lying on their sides for best results. In the model files, the parts are orientated in the direction best suited for printing. Use e.g. PETG for printing with a layer height of 0.2mm or less and a nozzle width of 0.4mm or less. A wall thickness of at least 3 lines and an infill of 25%. A support structure for the screw hole is recommended for the printing.