Pleater Box for Sally Stanley Smocking Pleater
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Box to assist with the use of a Sally Stanley Smocking pleater. It holds the spools of thread
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 748
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Box to assist with the use of a Sally Stanley Smocking pleater. It holds the spools of thread
I built this for someone I know, it is very specific and not a product many will want, but I figure why not share it just in case someone out there can make use of it. I do not plan to update or mod it, this is as is.
It is very large and will not fit on most printers, it is something like 330mm wide. The holes for the dowels are 6.25mm . The acrylic rods I got from Amazon said they were 0.24 inches/0.6cm and they fit tight and did not need any glue. Yes I did a poor job of cutting the lengths as they are not all the same. I used a Fine Razer Saw to cut them, if you take your time you can get them more even lengths, but it really has no bearing on the usage as long as they are all long enough for the spools.
I used PLA, nothing special. The Pleater fits nicely on top and does not move. You must use the narrow spools of thread like in the picture or bobbins otherwise there will not be enough room for all of them.
What if you really want this but have a small printer? Use your slicer to cut it in half and then glue it. There is not really any stress on the box so it should still work fine and for extra strength you could then glue the entire base to something.