Low Profile Racquetball feet for Ender 3 / 2040 / 4040 extrusions
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I loved the low-profile squash ball feet, but for some reason squash balls are expensive here! Racquetballs are about…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 135
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I loved the low-profile squash ball feet, but for some reason squash balls are expensive here! Racquetballs are about $2.50 for 3 however, so I remixed the feet to support the larger ball size. The end screw holes are not drilled out like in the original, but I found that these fit so snug there was no need for any screws at all to keep them in and secure.
After installing these I've noticed my enclosure gets MUCH less vibration transferred, and when some of the fancier top/bottom layer designs are running the printer doesn't shake nearly as much.
If you like the low-profile feet but can't get squash balls, use these!
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
.16
Infill:
30
Filament: Amazon PLA Grey
Notes:
Amazon PLA is ... interesting, often I get terrible prints for no reason. In this case, even with this low-quality filament these came out strong and solid. I think any filament will do a good job.
I imported the original into tinkercad, sliced the printer mount and the ball mount apart, then scaled up the ball mount and reattached it. It's ugly and quick, but so far it works extremely well.
Category: 3D Printer Parts
