Voxelab Aquila 2020 Extrusion caps
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple end caps for the upper X gantry on my Voxelab Aquila. After printing this, I wanted to fill in the 2020…
- Ocena
- 5 / 5
- Polubienia
- 56
- Pobrania
- 285
- Wydruki
- 6
- Wyświetlenia
- 1138
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
Simple end caps for the upper X gantry on my Voxelab Aquila.
After printing https://www.thingiverse.com/thing:4876137, I wanted to fill in the 2020 extrusion again, but the filament guide cuts into the available space.
Since I'm learning Tinkercad at the moment, I though I'd try my hand at replicating the stock caps, plus also design a custom one that accommodates the filament guide.
These will probably fit the Ender 3 v2 as well, but I don't have that printer to confirm.
Thought I'd post the result here in case it helps anyone else.
Edit: Added 2 new end caps, removing one of the tabs so that you can accommodate v-slot covers. I used these ones:
https://www.thingiverse.com/thing:4849882
Print Settings
Rafts: No
Supports: No
Resolution: 0.2mm
Infill: Not needed
Filament: Tinmorry PLA Orange
Notes: These are so small, they print in about 10 minutes.