Neptune 3 pro spiral drawers and trashbox
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed to be printed in spiral/vase mode
- Ocena
- 5 / 5
- Polubienia
- 48
- Pobrania
- 192
- Wydruki
- 1
- Wyświetlenia
- 776
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Insipired from other designs, I made this one from scratch. Trashbox sits right next to the bed and at exactly same height, convenient to remove those purge lines on the side of the bed. It slides in from the front, on built-in rails of the shell.
Intended to be printed in spiral/vase mode, with 1mm thick line. No supports. I used standard 0.4mm nozzle and with ~10mm³ flow it printed just fine. Shell is printed standing on its back and boxes are printed bottoms down. Adjust your bottom layers if you want thinner bottoms, model has 1mm thick everything, walls and bottoms. Tolerances are .3mm, should be enough for average printer.
Make sure your slicer prints the box separator, as shown in cura screenshot. In prusaslicer you have to set "slice gap closing radius" to 0.
Slides right in the slots of 2040 V-profile. You will have to unscrew 4 bolts in the front and one smaller bolt holding the plastic from the inside.