Flytron Strobon Strobe Light Mount for Skyhunter FPV Plane
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made this to hold the "Strobon" strobe light from Flytron, which you can find here: http://www.flytron.com/led-…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 257
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
I made this to hold the "Strobon" strobe light from Flytron, which you can find here: http://www.flytron.com/led-light-systems/99-strobon-navigation-strobe-light.html
It fits in the cutout on top of the Skyhunter's fuselage which I've yet to find a purpose for until now. I printed this upright, as it sits in the plane, because of the shape to match the fuselage. Printing it upside down might work, but will have some pretty wide overhangs on the sides. (If you try it let me know!) I printed it upright with supports under the bottom side in the cutout for the circuit board. There are some little posts that match the holes in the board, but you'll need some really short screws to work, with a diameter of about 2.5mm. The board is a snug fit and just pressed into mine, so I didn't bother with the screws. A little dab of glue will probably work just fine if your board is loose and you don't want to mess with the screws. The cable will pass through the hole into the fuselage. I printed this one with 3 walls and 20% infill, you might print with thinner walls and less infill for a little less weight, although it's not really heavy as is. ;)
Print Settings
Printer:
Anet A8
Rafts:
Doesn't Matter
Yes
Resolution:
0.2
20
Category: R/C Vehicles