Piano Key Balance Rail Punchings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Help regulate the height of your piano keys with these little punchings
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 115
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Share Alike
These little spacers let you adjust the balance rail on your piano for individual keys, letting you get them all aligned. These are intended to replace the little paper spacers, not the felt ones.
You'll definitely want to adjust the z-height of the model down to whatever your layer height is. Ideally, you'll want to print in increments of 0.15, 0.2, and 0.3mm (or whichever combinations make the most sense to you!) I got more than ~150 by filling my bed, so this should make a ton of extras.
It's probably a good idea to bump the perimeter count to whatever prevents infill on that first layer, too, to prevent filament from getting bunched up. YMMV!