1 / 4
Spinning top - up to 1min spinning time - easy print no supports — zdjęcie 1
1 / 4

Spinning top - up to 1min spinning time - easy print no supports

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An easy to print spinning top toy! Comes with 3 interchangeable tips (I recommend the ball shaped tip if you give the…

Ocena
0 / 5
Polubienia
2
Pobrania
40
Wydruki
0
Wyświetlenia
137
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

An easy to print spinning top toy!

Comes with 3 interchangeable tips (I recommend the ball shaped tip if you give the top to your kids)

Inspired by similar designs I thought it would be nice to design my own.

This is the result of several iterations, with some important design elements for long running times:

  • low center of gravity
  • most mass on the outer diameter for best flywheel effect
  • grippy handle piece for good accelaration
  • low air drag
  • "see through"-effect due to slim spoke design

Apart from that, its a nice 2hour-print with high sense of achievement ;-)

Print Settings

Printer:

Creality CR-6 SE

Rafts:

Doesn't Matter

Supports:

No

Resolution:

0.2

Infill:

60% for good weight of the outer ring

Filament:

A good one :-) PLA


Notes:

I recommend printing with at least 60% infill and 4 or 5 shells, to get a decent weight in the outer ring (the stick is hollow inside by design)
Print with heated bed, otherwise it is likely to warp after about 50% done... (guess why I know THAT?)

Post-Printing

Assembly :-)

Just chose a tip out of the three provided and push it gently in the hole.
It should seize tight in the conical hole (the tip base is same conical shape)

In the unlikely event the spin wobbles, check for untrue tip position. By turning the tip while pulling you might get it out again, otherwise use pliers. Try to correct position until wobbling disappears.

Have fun!

If you print and like it, I would be glad to see your make!

Category: Mechanical Toys

Tagi