Sinar/ intrepid 8x10 to Graflex adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allows you to use a Graflex speed graphic board in a intrepid 8x10 or other sinar board cameras.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 52
- Wydruki
- 1
- Wyświetlenia
- 420
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
wanted to use the lens that was on my speed graphic on my intrepid 8x10 but also didn't want to take it off of the speed graphic board as I still use it there. So a few searches and some trial and error later we have this.
I probably overkilled the print a bit but printed with 1.5mm walls and top and bottom, 60% infill in PETG.
To insert the holding pins I just used a torch and heated them up to almost melting and stuffed them into the holes. The slider you will need a couple of M3 screws and washers, a little pressure allows you to tap them into the plastic itself and they hold just fine (if you are concerned drop some epoxy or superglue into the holes just don't tighten things down so far you can't move the slide lock)