Bambu X1C Top Glass Riser remix for Neon-LED-Stripe (taller version)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a taller version of the remixed model by Tobi Höher
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 98
- Wydruki
- 1
- Wyświetlenia
- 973
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I've remixed a great also remixed glass riser by Tobi Höher (thanks a lot for the .step files that made it easy) https://www.printables.com/model/429534-bambu-x1c-top-glass-riser-remix-for-neon-led-strip
The main difference is to increase the height of the riser by 15 mm so that the PTFE tube has more space at the top and does not rub on the glass. In my remix the final riser height is about 27mm without PE foam tape. I used a PE self-adhesive foam tape 20 mm in width and 2 mm thick to make it more similar to the original design.
I printed with gray PETG on a Bambu X1C with a 0.4 nozzle with the following settings (Bambu Studio project file attached):
- layer thickness 0.28 - Extra draft preset
- 3 outer perimeters
- gyroid infill 15%
- supports auto/snug style
Total printing time for all 4 parts was about 11 hours, spent 385g of filament. I used the cheapest white LED 120 led/m that I already had (cost less than 10$ for 5m with power adapter), but you can use any from Aliexpress. Note to LED stripe section dimensions it should be about 5x11mm (in fact any cheap LED stripe has dimensions +/- 0.5-1mm). Don't buy a kit with a power adapter - the adapter is usually terrible.