Ender 3 V3 SE Centered CR Touch Mount

This is a Centered CR Touch modification for your Ender 3 V3 SE. Designed for use with dual 5015 fan ducts and K1 hotend.

Please follow all instructions below.

If you still have the stock block style hotend on your printer this mod will not work. If you would like to install this mod please upgrade to the K1/KE hotend or the following hotends.

This will work with the following hotends on your SE.

• K1/KE Ceramic Heating Block
• Micro Swiss FlowTech Hotend
• Trianglelab CHCB-OT Hotend

Requirements

1. Klipper (For .CFG changes)
2. K1 style hotend
3. M3x6 SHCS or BHCS 2pcs
4. Original M3 FHCS 1pcs

Dual 5015 Blower Duct

https://www.printables.com/model/667051-dual-5015-blower-duct-for-ender-3-v3-se

Instructions

1. Print your new CR Touch Mount, I recommend printing in ABS for longevity and durability. Recommended settings are 4 Walls, 8 Top/Bottom layers, 40-60% Infill.
2. Turn off all power and remove any previous mods on the hotend that will get in the way of installation.
3. Mount the new CR Touch Mount to your Sprite extruder with the required screws. 2 M3x6 screws for left side and original M3 FHCS for right side countersunk hole.
4. Restore power and make the following changes to your printer.cfg file.

Printer.CFG Changes

[z_compensate]

bl_offset:0,-36

[stepper_y]

position_max: 230

[bltouch]

x_offset: 0

y_offset: -36

[bed_mesh]

mesh_min: 20,20

mesh_max: 200,184

Enjoy the modification! It is still being developed and this is the first version being uploaded after a few revisions. I will update this mod to suit the original block style hotend soon.