PVC Pipe, conduit, and copper pipe clamp hangers / Clip / Mount. ½" - 2"

PVC, conduit, and copper pipe clamping hangers. ½" - 2" 

Lock your line in faster than any other hanger. These hangers automatically close when you press your line into the clamp. They have an unthreaded hole for mounting with a fastener.

The clamp arms have to flex to allow room to screw the clamp down and to push the pipe into the clamp. 

I print these in PETG and also have made them in TPU. TPU is not as strong, but is great to reduced vibrations for the pipe if there is any. 

Filaments used in the pictures : 

• HATCHBOX’s PETG Green 
  • Nozzle Temp - 240°C
  • Bed Temp - 70°C
  • Fill Density: 15% 

Assembly :

After printing, you will have to open the arms up to allow room to get a mounting fastener into the .1875" hole. Its best to use a long bit driver to reach down inside the clamp so you dont have to open the arms up to wide. 

To pipe will automatically close when you press your pipe into the clamp and push down with a little pressure. You will hear a nice click sound when it locks closed. 

Works with 

• SCH 40 & SCH 80 pvc pipe ½" - 2" 
• PVC, EMT and Rigid conduit. ½" - 2"
• Copper pipe ½" - 2". Note: With copper pipe, You will have to go down one size of clamp. 1" copper pipe would use a ¾" clamp. 

Enjoy :)