Anker Bolder Holder (for LC40 Flashlight) with USB cable holder

This is just a simple holder for an Anker LC40 Bolder LED flashlight (https://www.newegg.com/anker-lc40-hand-held-black/p/054-01ZZ-00017) and was inspired by (though not remixed from) twoforcemember's awesome LC90 Flashlight Holder (https://www.thingiverse.com/thing:3094682).

This holder also has a place to hang the end of a USB cable and a track to hold the cable for better cable management (sorry no pics but it is similar to my LC90 holder remix here (which shows how the USB cable management works): https://www.thingiverse.com/thing:4426841)

It can be wall mounted with some #8 wood screws. If wall mounting, I'd recommend getting the screws into wood so they don't pull out a drywall anchor.

When I printed mine, I printed it vertically (see the pics) which should give the holder more strength. I also printed in PETG which has a bit more flex than PLA (which could crack). Aside from that I would recommend using 3 walls and 20% gyroid infill and making sure your steps per mm and flow is calibrated (to insure dimensional accuracy), and your temp is hot enough to bond the walls properly. Mine fit perfectly when printed, but if you find it is too tight, some light sanding should do the trick.

If you print one please post a make. STEP file is included for remixing. The standard disclaimers apply; no warranty, no guarantee, don't run with scissors, print and use it at your own risk, etc. Comments are appreciated if you find something that could be improved.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Filament:

Duramic PETG white

Category: Outdoor & Garden