Bed-tester for Kobra 2(Print-in-place)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple tester for the bed(table). Strangely, this thing works.
- Ocena
- 5 / 5
- Polubienia
- 42
- Pobrania
- 134
- Wydruki
- 1
- Wyświetlenia
- 1072
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made this tester to solve the problem with the curved bed. And this thing helped me figure out that one corner was very bent. Auto level couldn't tune in.
Designed for printing with PET-G
Supports - No
Printing time - ~50min
Weight 10 - grams. I made light weight as much as possible.
Layer - 0.12-0.16mm (depends on the brand of the filament). Added a model for the test.
There may be a deviation of 0.05mm due to different filaments. I will be grateful if you add the made ones and write the plastic brand and printing settings.
Instruction.
It's simple
Insert the bottom part. 
Then fix the top. 
Check the vertical. 
Put your head on the base point. It could be any place.
Manually adjust the Z axis until the arrow points to the center of the tester. 
Move the table and head smoothly. Watch the arrow.
I first leveled the cold bed, then heated it to 60° and leveled it more precisely.