OnePlus Nord N200 Case TPU
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix from a design that I liked but wanted to improve upon to print in one piece in TPU
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 113
- Wydruki
- 0
- Wyświetlenia
- 446
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I was looking for a phone case for the N200 and this was the only good design, but it was for PLA and printed in two pieces. I wanted to print it in TPU so I connected both pieces into a single print and added some features. You can one-shot this print and it comes out great!
Settings:
Printed in TPU at 0.2 layer height with some supports, and it fits well. (Would probably recommend at least a 0.16 height, I just wanted to print this quickly and make sure all the measurements were good.) Not sure if this would work with PLA, but I guess you could give it a try.
P.S - I'm new at modeling, so this was my best attempt, I think it came out good.
Enjoy!