DUMMY 13 costume - Batman

Yet another Dummy13 Caped Crusader!

My Batman has a newly designed cowl, a broad chest, abs, a cape, a utility belt, a batarang, and a holster for the batarang 

I used the 2x Muscled arm for dummy13 and the Hunky variant

Note, all of my Dummy 13 models are printed at 150% and I doubt you'd be able to print a lot of these details at 100%.  You've got to have a well-calibrated printer to print dummy 13, and these parts are no exception. Some parts will need supports, but it probably depends on your printer.

Unless specified otherwise, use the parts from the original Dummy13 by Soozafone

• Black
  • Frame:
    • frame-head
    • frame-neck (or my solid-neck)
    • frame-chest
    • 2x Hunky_clavicle_2mm_added_for_hip_armor
    • 4x frame-hip-shoulder
    • 2x frame-upper-arm
    • 2x frame-forearm
    • 4x frame-knee-elbow
    • frame-abdoment
    • frame-hips
    • frame-waist
    • 2x  Hunky_longer_thigh
    • 2x  Hunky_longer_shin
    • 2x frame-ankle
  • Armor:
    • BatmanHead
    • BatmanCowl – Fits tightly as-is, scale it up by 1 or 2 % to make it easy to take on and off
    • armor-neck (unless you're using the solid-neck from above)
    • BatmanChest
    • armor-chest-lower
    • 4x Dummy13 armor-hip (2 for hips, 2 for hunky shoulders)
    • 2x armor-upper-arm or  2x “New 2x uper arm dummy 13”
    • 2x BatmanForearm 
    • BatmanAbs
    • armor-crotch
    • armor-waist
    • 2x armor-knee
    • 2x armor-thigh
    • 2x armor-shin
    • 2x armor-foot
    • 2x armor-toe
  • Accessories
    • BatmanCape
    • LegHolster
    • Batarang
• Yellow
  • Logo
  • Belt, belt buckle, pouches, greeblies.  I did 4 pouches and 2 greeblies. All of the pieces snap on to the belt, but I found that it needed superglue.
• Tan
  • BatmanHead
• White
  • BatmanEyes

For the cape, I've done two different approaches. I printed with 45% Gyroid Infill, 1 top layer, and 1 bottom layer. Then I hit it with a heat gun to soften it and wrinkled it while it was warm.

• Fresh off the printer:

• After heating and bending the left edge:

• After shaping the whole thing:

Alternatively, you can use the approach laid out in multiuse flexible fabric. I used a height modifier to only enable top/bottom layers for the part of the model that clips onto the back.