mt32-pi MiSTer HAT Shim
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a "shim" piece for the mt32-pi MiSTer HAT that goes between the circuit board and the top plate to cover the…
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 68
- Wydruki
- 1
- Wyświetlenia
- 1375
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a "shim" piece for the mt32-pi MiSTer HAT that goes between the circuit board and the top plate to cover the open edges of the stacked boards.
Designed for use with 8mm standoffs and the right-hand-side USB port only.
See photo for assembly guidelines when using with the Ugeek/Geekworm aluminium case.
The aluminium case's standoffs have short female screwholes, and most standoffs have a 6mm male thread, which will "bottom out" before fullly tightening the PCB down. Therefore, try to find M2.5x8mm standoffs with a shorter male thread, maybe around 3-4mm. Or, you can do as I did and use a Dremel to trim the threads shorter.
New: Versions with ON/OFF text for the power switch now included.
New: A version with space and 3.5mm jack cutout for a GY-PCM5102 DAC module has been added. This lets you "hack" the HAT with a high-quality analog output by soldering wires onto the protruding GPIO header pins.
No-standoff alternative: Versions with smaller holes are included in case you don't want to use standoffs. In this case, you can use long (~12mm) M2.5 cap screws to go through the top PCB, shim, and bottom PCB directly into the aluminium case.
Buy prints of this item
I offer prints of this item in my Ko-Fi shop:
https://ko-fi.com/s/55a59d3404
Support my work
If you like my designs, please consider making a donation via my Ko-fi page. Thanks!
Category: Electronics