Nevermore V6 Plenum for West3d's Berserker Vindr Fans
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Nevermore V6 plenum modified to fit West3d's Berserker Vindr fans with minimal plastic cutting.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 74
- Wydruki
- 2
- Wyświetlenia
- 1115
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
In order to fit the fans into the plenum a few small cuts need to be made with flush cutters. I highly recommend wearing safety glasses when trimming pieces off of the fans as they WILL go flying.
First: cut off the wire retention clip on both fans.
Second (OPTIONAL): For easier assembly the mounting hole on one of the fans can be trimmed down. when looking at the fan from the back trim the lower left mouting hole as shown in the pictures.
and that's it for fan modifications!
Next you need to remove the build in supports, check the Nevemore V6 github page to see exactly what needs to be removed. https://github.com/nevermore3d/Nevermore_Micro/tree/master/V6
The fans can now be inserted into the plenum. The fan with the trimmed mounting hole needs to be installed on the right side. The easiest way to get the fans into the plenum is to put both fans in half way at an angle and then push both of them together in the middle (see the gif).
Just like the regular V6 plenum you will need to print two fan clamps to hold the fans in place. I have also slightly modified the clips to accomodate the Vindr fans.