Creality Ender 3v3SE Fillament Runnout Sensor Reverse Bowden Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A reverse bowden tube adapter for the official Ender 3 V3 SE/KE sensor. Allows use original bracket.
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 112
- Wydruki
- 0
- Wyświetlenia
- 2067
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
A reverse bowden tube adapter for the official Ender 3 V3 SE/KE sensor. Allows for the use of the original bracket.
Important
The sensor has the filament port slightly offset in both the X and Y direction. See the pictures for correct orientation.
The top and bottom are designed with alignment pins/arrows. Do not force them together without double checking.
Required additional parts
- Four (4) M3x8 Flat head screws.
- Two (2) M10 Push to connect fittings.
- (Optional) M10 Tap
- (Optional) Two (2) M3x4 Flat head screws.
The M10 holes are printed upright, so a M10 tap can help. The two shorter screws are used to attach the original bracket to the top plate.
My Print Settings
- 0.1mm Layer height
- 15% infill
- Supports with max overhang angle set to less than 60 degrees.
Other Notes
There is also a slim top available if you do not want to use the original bracket, and want a more unique look.
If you do not want to use the original holder, I recommend using this: https://www.printables.com/model/786450-ender-3-v3-kese-filalent-sensor-mount
Similar Models / Ideas
https://www.printables.com/model/548595-creality-filament-detection-connector