1 / 8
Polaroid Picture Frame for SX-70 and 600 Film
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Frame your Polaroid pictures with a bit of a Lego twist.
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 387
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (34)Powiązane
There ist a version with included break-away supports (recommended) and a version without supports where you really should support the long bridge at the top of the frame.
The model was created using Tinkercad and can be found here.
Let me know if you have ideas on how to improve the Lego compatibility (the slot at the top causes some issues there).
Tips
- Prints fine with PLA and PETG (tested)
- Put seam to the back
- Use brim (better safe than sorry)
- 10% infill is enough