Broom Handle Bracket / Broomstick Mount (4 sizes)

Remix of SD-3Ds broom bracket with added screw holes.

Please also check the original posting which has been recently updated.
This remix here also received the stabilization add in V2. Which SD-3D implemented when touching the original model again.
 

The remaining differences between this remix and SD-3D original: 

• The original uses one thick screw, where this remix is intended to be used with up to 4 smaller screws to fixate the broomstick.
• The remix has the center hole all the way through. This helps a tad with stability since the broomstick is a tad closer to the broom. 

Available sizes:
24mm, 25mm, 28mm and 30mm wide broom-stick sizes.

The title pictures show deprecated V1 in white, and V2 in orange. 

 

Assembly:

• Double-check the inner diameter of the hole. If you've printed with too much tolerance or used a filament prone to shrinkage, it's straightforward to widen the hole slightly using sandpaper wrapped around your finger. Alternatively, you can narrow the diameter of the broomstick by sanding it down a bit.
• For the remix, it's essential to first attach the bracket to the broom part. Since the hole extends all the way through, positioning the broomstick otherwise may prove challenging.
• Once you've secured the bracket to the broom, insert the broomstick into the bracket as far as possible by hand. Then, repeatedly tap the broomstick upright (with the broom and bracket on top) onto the very stable floor to utilize gravity to fully seat the bracket and attached broom onto the broomstick.

If you want to support me, please check my other models!

I do very niche projects mostly. Thus, understandably, only few of my models become popular.
But chances are high that you can find inspiration from my specialized works.
https://www.printables.com/@moWerk/models

Thank you and happy printing!