1 / 4
Nozzle for JPN Extruder for CMYK+ colorprinting — zdjęcie 1
1 / 4

Nozzle for JPN Extruder for CMYK+ colorprinting

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I wonder if something like this might work. Possible to either machine in two parts or even one block? The PTFE tubes…

Ocena
0 / 5
Polubienia
1
Pobrania
6
Wydruki
0
Wyświetlenia
106
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I wonder if something like this might work.
Possible to either machine in two parts or even one block?

The PTFE tubes enters the into nozzle (like in MK10) but the nozzle acts also the heating block.

Obviously the tricky part is to drill those 0.4mm channels? The entering channels crossing forms the cavity to allow colors to mix.

Keeping filaments separated as far as possible reduce the hysteresis and there for filament waste, when the sharp color change is needed.

Category: 3D Printer Extruders

Tagi