Snap-in Air Fan Shroud v2 for CTC i3 MK8 extruder with the metal holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is based on the http://www.thingiverse.com/thing:1243891 idea. Though this is 5mm shorter to fit with the…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 269
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is based on the http://www.thingiverse.com/thing:1243891 idea.
Though this is 5mm shorter to fit with the aluminum extruder holder. As this comes very near of the hot end a sheet of foil as a heat shield is recommended.
The shroud should be bind in to its place to enhance the air tightness and avoiding the waggle.
Updated version: Have a lip, which secure the shroud over the Fan bolt. Air outlet added also on the side.
Print flat side down and remove supports on the lip and air inlet.
Category: 3D Printer Parts