Switch Cover HPM Architrave Switch Dual/Single
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cover for the HPM Mini Architrave Light Switches sold in Australia
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 29
- Wydruki
- 1
- Wyświetlenia
- 271
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model I designed to cover over the standard HPM dual architrave switches found in many Australian Homes.
I primarily use this for covering switches where the lights are smart bulbs I have incorporated into my smart home, and therefore do not need to be accessed.
There are two Variants of this Model:
Half
For use when only one switch is in use by the smart home (for example, when one switch is used for florescent tube lighting) Has a smooth fillet to allow for switching on and off of the second switch.
Full
For use when both switches need to be covered, this can be used on single and dual switches (I've used it on both)
These models are designed to use minimal plastic, and have a little wiggle room to position them more accurately over the switches themselves. I've adhered them with blu-tack or nano tape, but any non-permanent adhesive will be fine, if your tolerances are out you may be able to get away with friction fitting these alone.
They are best printed on their side, with supports, that ensures that you don't need to post process the exposed part of the cover much at all.
I've successfully printed these in PLA and PET-G.
Standard Settings
Layer Height: 0.2mm
Supports: Yes (tree supports recommended)
Brim: Recommended but not necessary
Wall Thickness: 2 Layers (this should print the whole part solid)
As always with my original models, STEP files are included in case you need to modify or remix.