Tablet holder for indoor trainer

Needed a tablet holder for indoor trainer, OEMs cost about 80eur so I said no.
Found multiple ones but none of them had exact specifications for tablet or handle bar, or were really complex or just didn't work with Wahoo Kickr Shift handle bar.

So I made my own taking some design ideas from others I found. 

It's made for Wahoo Kickr Shift, but as it uses regular 31.7mm handlebar it could fit others too. Also critical measurement is that this is for max 7mm thick tablets. I could edit it for bulkier if there's ask for it or you can do that in prusaslicer. Works with 6mm wide, 1.9mm thick cable ties, there's internal routing for it.

For mounting I put little gorilla tape for extra grip on the handlebar (it does work without it too) and then tightened both with cable ties when tablet is at optimal angle etc.

As you can see from the image, there is also plenty of room for bike computers etc.

For printing I used PLA, 0 top and bottom layers, 10% gyroid infill and 4 perimeters. Only one model file, you can mirror it in the slicer.

 

edit: Not my favorite self made model at the moment, needs a little work to hold tablet in place.