Oil pump worm gear for Husqgvarna, Jonsered and McCulloch chain saws
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For Husqvarna 120 MARK II 230 235 236 240 Jonsered CS2234 CS2234S CS2238 McCulloch CS340 CS380
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 444
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
Frequently used repacement part for chainsaws.
I recommend printing from polycarbonate.
3D model contains both plastic and metal parts. Metal part is there for position reference only - position of inclined guide groove and the D groove on the metal axle must be respected otherwise it won't work! Take a good look at it and then split parts in slicer.
Then just cut off broken plastic part and press new printed part in right position.
On this type of saws there if also problem with thin plastic cover around the main axis. When the cover breaks, wood shavings enter the pump gearing and then the oil pump fails, so I also included replacement cover, which is originaly part of the oil pump body, but usually it breaks after few cuts.
It works fine for me, but today I hit a stone or someting, so now I'm going to sharpen the chain.