1 / 2
Gotrax G4 Airtag holder left rear reflector — zdjęcie 1
1 / 2

Gotrax G4 Airtag holder left rear reflector

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Airtag mount for GOTRAX G4 electric scooter. This should fit the G3 and GMAX Ultra since they use the same reflector.

Ocena
0 / 5
Polubienia
4
Pobrania
30
Wydruki
0
Wyświetlenia
634
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial

Airtag mount for GOTRAX G4 electric scooter. This should also fit the G3 and GMAX Ultra since they use the same reflector. My son's left rear reflector broke off his scooter so I decided it would be a good spot for an inconspicuous airtag mount. This uses the factory screws for a quick and easy install. Print with 2mm walls for added strength. Both pieces print in 1 model. Supports needed for the airtag cavity. You won't see the inside, so the support interface quality isn't an issue.

Installation: Pop out the supports and put your airtag in. The circle piece covers the airtag. Seal with a little hot glue if desired. Installation consists of removing the left rear reflector assembly and replacing with this assembly using the factory hex cap screws.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Yes

Category: Parts

Tagi