3d Printed Stack able Turning Earring Holder

I designed this for vending events I go to and was told I should post the files so I decided to go ahead and do that… I printed this on my Sovol SV06+ using what I had left of a few different spools.This is fully stack able and the sky is the limit basically. The Caps are for the top and the bottom of however big you make it. The Connector pieces go in between the stacks. I use a SL-M NC 2b 10:31 PVC Pipe for the pipe in the middle that it turns around. Make sure the base is fully cooled before taking it off the build plate or it might warp. The Cross Sections go on the inside connected to the Middle Connector and Middle Caps and I did not glue those together because it kind of helps it self adjust if its not exactly level to make it so it spins level. There is a file that is half a sphere that I glued on top of the base in the middle hole which helps it glide better around and The base is full of holes because it cuts back on filament and time and doesn't seem to cause any issues. I didn't need Supports of anything but I did have do a brim around the parts just so the ends didn't warp. Sorry I'm still learning how to post stuff I made and I hope you enjoy and would love to see some remixes of any issues a person might have.