1 / 18
Railcore II Y carriage for E3D Titan Aero and Blower Shroud — zdjęcie 1
1 / 18

Railcore II Y carriage for E3D Titan Aero and Blower Shroud

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a new Y carriage for the Railcore 2 to use the E3D Titan Aero extruder and a new blower shroud using the EBM-…

Ocena
0 / 5
Polubienia
1
Pobrania
7
Wydruki
0
Wyświetlenia
186
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a new Y carriage for the Railcore 2 to use the E3D Titan Aero extruder and a new blower shroud using the EBM-PAPST RLF35-8/14N 5cm blower. Also included is a mount and cover for an IR auto leveling sensor. Tested and working great. Orient the parts so that they print best on your printer. I added the parts required to use a breakout board to connect the head. I used 2 breakout boards for a Wanhao D6/D9 and a 1m 20 lead ribbon`cable. Did not use the 3 pin proximity probe connection on the board as they are connected to a transistor and two resistors on the underside of the board. Also I do not run the heater connection through the ribbon cable. Added a E3D Copper Volcano and brass nozzle.

4x 6mm M3
6x 12mm M3

I made another shroud for an inductive proximity probe as the IR probe didn't work well enough with my PEI bed. thing:3313942

Modified to ad a Duet3D IR laser filament sensor thing:3573588

Print Settings

Printer Brand:

Monoprice

Printer:

Maker Ultimate

Resolution:

0.150

Infill:

50%


Filament:

Atomic filament Carbon fiber PETG

Category: 3D Printer Parts

Tagi